The "PUMP" Air Pump Manual

 Safety Device Replacement

1. Cautions when setting the SM Bar
  1. First remove the pump plug from the electrical outlet.
  2. Dispose of the broken SM bar.
  3. Make sure the handle is set vertically.
  4. Only install the bar after the diaphragm has been changed.
  5. If the bar is not completely pressed into position in the retaining slot, it will cause irregular operation.
  6. Do not connect the switch directly to an electrical outlet or change the wiring arrangement in any way.
  7. The SM switch bar differs according to the pump type.

Next Page - Table of Contents